🚚 Free Shipping on Orders $89+

✅ Money back guarantee, no questions asked

All Products

  • Shop all Products

How-To

How-To guide

How to Use the Wash Wax Mop

Wash, wax and dry high areas from the ground with one mop: a damp Wet side to clean, a Dry side to buff. No ladder needed.

  • About 20 minutes for an RV side
  • 3 products needed
  • Video guide

Step by step

  1. Prime. Spray the Wet side with 10-20 pumps of Wash Wax ALL. (This is to prime a new dry pad.)
  2. Spray on. Spray Wash Wax ALL on the area to be cleaned. We recommend about one spray pump per square foot.
  3. Wet side. Wipe the area with the Wet side of the mop.
  4. Dry side. Flip the mop over to the Dry side and dry the area before the Wash Wax ALL dries on its own.

Note: To apply Wash Wax ALL to hard to reach areas, rotate the sprayer nozzle to stream and spray Wash Wax ALL on to the surface, or spray directly on to the Wet side of the mop and then wipe the area. Once the Wet side pad gets dirty, replace it with the Dry side pad and put a fresh clean pad on the Dry side.

Helpful tips

  • The Wet side should only be damp. Do not over-saturate the Wet side or you may begin to see streaking. If it gets over-saturated, stop spraying and keep cleaning new areas until the Wet side is only damp. The most common mistake is using too much Wash Wax ALL.
  • Top down: clean the high areas first to prevent spray mist from landing on clean areas.
  • Stay up-wind: keep the dirty areas downwind of your cleaning spray.
  • Windows last: after all painted surfaces are clean, put two fresh pads on the mop head and clean the windows.
  • Hot and dry vs. cold and damp: when it's hot and dry the surface dries faster, so do smaller areas at a time. When it's cold and damp, do larger areas.
  • Do not place the mop on the ground. The pads may pick up contaminants that can scratch the surface.
  • Inspect mop pads and towels for contaminants after washing and before each use.
  • Store mop pads and towels in a dirt-free container or bag.
  • Tighten the nut so the mop does not pivot too easily. It should give some resistance when you pivot the head by hand.
  • The swivel locking screw: leave it locked when you first start. Once you are comfortable, remove it with a screwdriver and store it in the bottom hole. Unlocked gives more flexibility; it is your preference.

WARNING: The mop was developed to eliminate the need for a ladder. Do not use the Wash Wax Mop from a ladder: you cannot use the mop and hold on to the ladder at the same time, which increases your chances of falling.

Questions? Talk to a real person.

We make it in San Antonio, so we know it. Call or email us.